Pontiac 89018113 Starter Asm,(Remanufacture)(Pg260D)

You can Select Your Vehicle to check if 89018113 fits your vehicle.

Remove the cable from the battery's negative terminal. Lift and support the vehicle on jackstands for four-cylinder and 3.0L V6 models. Disconnect all the wiring from the starter. It disconnects with both batteries and starter solenoid wiring. On 3.5L V6 models, pull back the rubber boot until an electrical connector can be pulled off, then remove nut, pull back rubber boot, and remove starter cable. Remove any brackets that are in your way, undo the starter mounting bolts, and take out the starter. This is inclusive of both upper as well as lower mounting bolts of a 3.5L V6 model starter unit. Move it around to clear the block and bellhousing then pull it out. Failure to follow these cautions may result in damage to your equipment or injury to yourself or others. Install by reversing the procedure described above. Refit all components removed during dismantling.

Raise the front of the vehicle and place it securely on jackstands.

Raise the front of the vehicle and place it securely on jackstands.

The damaged battery cables should be replaced.

Raise the front of the model and place it securely on jackstands.

The first step is to disconnect the cable from the negative battery terminal.

If the starter is slow-turning, you should assess the cranking voltage and current draw, ensuring the battery meets specifications, terminals and cables are clean, and considering cold temperatures' impact.