GMC 19152704 Shoe Kit,Rear Brake

You can Select Your Vehicle to check if 19152704 fits your vehicle.

To remove the rear brake shoe, start by loosening the lug nuts on the rear wheels and raising the vehicle securely on jackstands. Release the parking brake and block the front wheels. Remove the rear wheels and then take off the brake caliper, mounting bracket, and brake disc. Pull the equalizer towards the rear of the vehicle from underneath to expose the inner parking brake cable and clamp it with padded locking pliers to relieve tension on the rear cables. Clean the brake assembly with brake system cleaner and slide the shoe downward to clear the retaining clip, then slide it up and off the actuator. Lift one end of the shoe over the axle flange and remove it. Before installing the new shoe, turn the adjuster screw star wheel in and ensure that the slots in the adjusting screw and tappet are parallel with the backing plate. To install the new shoe, reverse the removal procedure by sliding it under the retaining clip and making sure the ends of the shoe seat properly in the slots of the adjuster screw and tappet. When installing the new shoe and lining assembly, turn the adjuster screw until the shoe lining just drags on the braking surface inside the disc. Then remove the disc and back off the adjuster screw until the shoe lining doesn't drag when the disc is installed and turned. The clearance between the lining surface of the shoe and the braking surface inside the disc should be 0.026-inch. Finally, complete the installation by following the reverse of the removal procedure, ensuring to tighten the caliper bracket bolts, caliper mounting bolts, and wheel lug nuts to the correct torque specifications.

Loosen lug nuts, raise the rear of the vehicle, and support on jackstands. Block the front wheels, release the parking brake, and remove the wheel. Inspect the drum for cracks, scratches, or hard spots. If present, have the drum machined. After inspection, place the brake drum on the axle flange. Mount the wheel, tighten lug nuts, lower the vehicle, and adjust the brakes with forward and reverse stops for proper pedal action.

To remove the rear brake shoe assembly, start by loosening the lug nuts on the rear wheels and raising the vehicle. Securely place it on jackstands and remove the wheels. Then, take off the rear brake calipers and discs. Slide the parking brake shoe assembly straight down to remove it. For installation, lubricate the shoe guide pads with high-temperature grease and install the new shoe assembly. Repeat these steps for the other side. After that, install the brake discs and calipers. Finally, put the rear wheels back on, remove the jackstands, and lower the vehicle. Make sure to tighten the wheel lug nuts to the proper torque specifications.

Slide the parking brake shoe assembly straight down to remove it.

After blocking the front wheels, you should remove the rear wheels and then the brake drum.

Release the parking brake and block the front wheels.

Start by loosening the lug nuts on the rear wheels and raising the vehicle.

The first step is to loosen the wheel lug nuts and raise the rear of the vehicle, securely supporting it on jackstands.

After checking the brake pedal position, you should test the brakes for proper operation before driving in traffic.

If the brake drum is locked onto the shoes, you can use a screwdriver to push the actuator lever off the star adjuster and back off the adjuster wheel.