Make sure this part fits

GM 24504460 Cover, Engine Front

1996-1997 GM

Customer Questions & Expert Answers (10)
GM 24504460 Cover, Engine Front
  • Part Description
    COVER, Engine Front Cover
  • Position
    Front
  • Manufacturer
    General Motors
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Related Parts
  • Product Specifications
  • Vehicle Fitment
  • Customer Questions & Expert Answers
  • Product Specifications

    BrandGenuine GM
    Manufacturer Part Number24504460
    Part DescriptionCOVER, Engine Front Cover
    Other NamesFront Cover, Lower Timing Cover
    Item Dimensions24.2 x 20.0 x 4.8 inches
    Item Weight17.50 Pounds
    PositionFront
    ConditionNew
    Fitment TypeDirect Replacement
    ManufacturerGeneral Motors
    SKU24504460
    WarrantyThis genuine GM part is guaranteed by GM's factory warranty.
    Shipping & ReturnShipping Policy Return Policy
    Warning: California’s Proposition 65
  • Vehicle Fitment

    Year Make Model Engine Important vehicle option details
    1996-1997 Chevrolet Lumina6 Cyl 3.4LLS, LS 4 DOOR, LTZ 4 DOOR, LUMINA, MONTE CARLO
    1996-1997 Chevrolet Monte Carlo6 Cyl 3.4LLS, LS 4 DOOR, LTZ 4 DOOR, LUMINA, MONTE CARLO
    1996 Oldsmobile Cutlass6 Cyl 3.4L2 DOOR, 4 DOOR
    1996 Pontiac Grand Prix6 Cyl 3.4L2 DOOR, 4 DOOR, GT 2 DOOR, SE 2 DOOR, SE 4 DOOR
  • Customer Questions & Expert Answers

    Q:
    I would like to confirm if this is the correct part number for my vehicle. Please advise. Thank you. Posted by GMPartsGiant Specialist
    A:
    You can Select Your Vehicle to check if 24504460 fits your vehicle.
    Posted by GMPartsGiant Specialist
    Q:
    How should the new front pan seal be prepared and installed for the 1997 Oldsmobile Cutlass? Posted by Customer
    A:
    Trim about One-quarter inch from each end of the new front pan seal, install a new gasket to the engine block and a new front seal on the cover with sealant. Then, tilt the cover into place, compressing the lower pan seal while guiding it into the cavity.
    Posted by GMPartsGiant Specialist
    See expert answers on similar Timing Cover
    Q:
    What should be done with the distributor for the 1988 Oldsmobile Cutlass? Posted by Customer
    A:
    Take out the distributor, ensuring to mark the position of the distributor rotor if the timing chain and sprockets remain undisturbed.
    Posted by GMPartsGiant Specialist
    Q:
    How should the bolts be installed for the 1989 Pontiac Grand Prix? Posted by Customer
    A:
    Apply thread sealant to the bolt threads and install them finger tight, then install the crankshaft sensor but leave the bolts finger tight until the next step.
    Posted by GMPartsGiant Specialist
    Q:
    What is the final step in the installation process for the 1994 Pontiac Grand Prix? Posted by Customer
    A:
    Reinstall the oil pan and complete the installation by reversing the removal procedure.
    Posted by GMPartsGiant Specialist
    See expert answers on similar Timing Cover
    Q:
    What should be done after raising the engine for the 1997 Pontiac Grand Prix? Posted by Customer
    A:
    Remove the timing chain housing and gaskets, ensuring to clean the mating surfaces thoroughly.
    Posted by GMPartsGiant Specialist
    Q:
    How do you access the front and rear covers for the 1988 Pontiac Grand Prix? Posted by Customer
    A:
    Start by removing the spark plug wire cover for the front cover only. For models from 1996 and later, take out the ignition coils and the coil mounting bracket to reach the rear cover.
    Posted by GMPartsGiant Specialist
    Q:
    Can the timing gear of the 1995 Pontiac Grand Prix be removed? Posted by Customer
    A:
    No, the timing gears on 1990 and earlier models cannot be removed in the vehicle.
    Posted by GMPartsGiant Specialist
    Q:
    What components should be removed after the timing belt and idler pulleys for the 1997 Pontiac Grand Prix? Posted by Customer
    A:
    Proceed to remove the front engine lift bracket, cooling fans, and disconnect the coolant hoses from the water pump.
    Posted by GMPartsGiant Specialist
    Q:
    What should be done with the water pump pulley bolts for the 1993 Pontiac Grand Prix? Posted by Customer
    A:
    Loosen the water pump pulley bolts without removing them, then take off the serpentine drivebelt.
    Posted by GMPartsGiant Specialist
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

Genuine GM Part 24504460, the Right Choice

To ensure reliability, purchase GM part # 24504460 Cover, Engine Front. It is sometimes referred to as GM Timing Cover. Directly from GM, genuine parts are superb with regards to quality, longevity, and fit. Every single part passed stringent quality testing, so you can be sure that it's safe, durable, and built to perform like your original parts. This part fits specific Chevrolet Lumina, Monte Carlo models. It fits Oldsmobile Cutlass. It also fits Pontiac Grand Prix.

GMPartsGiant.com is a leading supplier of genuine GM parts and accessories such as GM 24504460 Cover, Engine Front. You're certainly in the right place if you're searching for the great cost-effective OEM GM parts. Look no further than our vast inventory of genuine GM parts offered at unbeatable online prices, all of which are backed by the manufacturer's warranty. Not to forget, our hassle-free return policy and quick delivery service ensure a smooth shopping experience for you. For detailed Chevrolet parts information, click here.

Why choose GM Parts Giant

  • Dedicated Service

    Your complete satisfaction is our #1 goal

  • Lowest Prices

    Best deals on genuine OE parts from dealerships

  • Fast Delivery

    Orders are processed and delivered promptly