GM 15552822 Cable Assembly, Accelerator Control

You can Select Your Vehicle to check if 15552822 fits your vehicle.

Disconnect the cable from the negative battery terminal. Caution: On models equipped with the Theftlock audio system, be sure the lockout feature is turned off before performing any procedure which requires disconnecting the battery. Access the throttle body by removing the air filter assembly from the TBI unit on TBI systems, or by removing the air intake duct and resonator from the throttle body on Central SFI and MPFI systems. Detach the cruise control cable from the throttle lever, if equipped. Rotate the throttle lever and separate the throttle cable end from the throttle lever by passing the cable through the slot in the throttle lever. Depress the locking tabs on the cable housing and push the cable housing through the bracket, then detach the cable from the cable routing retainers. Remove the trim panel from under the dash and detach the cable from the accelerator pedal by pulling the accelerator cable retainer out of the pedal and sliding the cable through the slot. Depress the locking tabs on the cable housing and push the cable through the firewall and into the engine compartment. Finally, remove the cable from the engine compartment. Installation is the reverse of removal.

The cable may appear to function properly with the engine stopped and cold, but it should be rechecked after the engine is hot.

With the engine off, depress and hold down the metal re-adjust tab at the engine end of the TV cable. Move the slider until it stops against the fitting. Release the re-adjust tab. Rotate the throttle lever to its full travel position. The slider must move toward the lever when the lever is rotated to its full travel position. Make sure the cable moves freely.

Be sure the lockout feature is turned off.