Cadillac 12552129 Sprocket,Camshaft

You can Select Your Vehicle to check if 12552129 fits your vehicle.

To install the timing chain cover, you need to follow these steps: 1. Clean the engine block sealing surfaces. 2. Align the keyway in the crankshaft sprocket. 3. Press the sprocket onto the crankshaft. 4. Align the balance shaft gears. 5. Position the crankshaft and loop the chain over the camshaft sprocket. 6. Apply thread locking compound to the camshaft sprocket bolt threads and tighten them. 7. Install the crankshaft position sensor reluctor ring. 8. Apply RTV sealant to the engine block sealing surface. 9. Position the new front cover and oil seal assembly. 10. Tighten the cover retaining bolts. 11. Install the oil pan. 12. Install the vibration damper. 13. Install the crankshaft position sensor.

To remove the timing chain cover, you need to follow these steps: 1. Disconnect the cable from the negative terminal of the battery. 2. Drain the cooling system. 3. Remove the cooling fan. 4. Take off the water pump. 5. Remove the drivebelt pulley. 6. Remove the vibration damper. 7. Remove the crankshaft position sensor and the wiring harness nut. 8. Remove the oil pan. 9. Disconnect the wiring harness clips from the front cover. 10. Remove the crankshaft position sensor and the camshaft position sensor with its jumper wiring harness. 11. Remove the cover bolts. 12. Separate the timing chain cover from the block. 13. Remove the crankshaft position sensor reluctor ring. 14. Measure the timing chain free play. 15. Replace the chain and sprockets if necessary.