Q: How do you remove the rear hub and bearing for Saturn Vue?
A: In order to eliminate the hub and bearing assembly, begin by undoing the rear part of AWD models drive axle/hub nut. Then slacken the wheel lug nuts, jack up the truck, and properly ensure it is supported with jack stands. One can then remove the wheel and brake drum. On AWD versions, wire should be used to secure the end of the drive axle after removing right front drive axle spindle nut. If ABS is fitted then disconnect wheel speed sensor. Finally, take out guide hub and bearing from brake assembly four hub mounting bolts.To install Hub and bearing assembly follow same steps but in reverse.Beginning with all four bolts installed,tighten till each reaches its torque specification.AWD models require a new drive axle/hub nut that must be tightly fixed (final tightening will be done after lowering the vehicle).After installing brake drum &wheel,lift vehicle and retighten torque specifications.