Other Name: Radiator Assembly, Chrg Air Clr; Intercooler, Radiator
Replaces: 22799480
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2016-2022 Chevrolet Camaro | 2 DOOR CONVERTIBLE 1LS/1LT, 2 DOOR CONVERTIBLE 1LT, 2 DOOR CONVERTIBLE 2LT, 2 DOOR COUPE 1LS/1LT, 2 DOOR COUPE 1LT, 2 DOOR COUPE 2LT | 4 Cyl 2.0L
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2016-2022 Chevrolet Camaro | 2 DOOR CONVERTIBLE 1LS/1LT, 2 DOOR CONVERTIBLE 1LT, 2 DOOR CONVERTIBLE 2LT, 2 DOOR COUPE 1LS/1LT, 2 DOOR COUPE 1LT, 2 DOOR COUPE 2LT | 4 Cyl 2.0L, 6 Cyl 3.6L
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2016-2022 Chevrolet Camaro | 2 DOOR CONVERTIBLE 1SS, 2 DOOR CONVERTIBLE 2SS, 2 DOOR CONVERTIBLE HIGH PERFORMANCE, 2 DOOR COUPE 1SS, 2 DOOR COUPE 2SS, 2 DOOR COUPE HIGH PERFORMANCE | 8 Cyl 6.2L
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2016-2022 Chevrolet Camaro | 2 DOOR CONVERTIBLE 1LS/1LT, 2 DOOR CONVERTIBLE 1LT, 2 DOOR CONVERTIBLE 2LT, 2 DOOR COUPE 1LS/1LT, 2 DOOR COUPE 1LT, 2 DOOR COUPE 2LT | 4 Cyl 2.0L, 6 Cyl 3.6L
Q: How do you remove the radiator for Chevrolet Camaro?
A: To remove the radiator, start by disconnecting the cable from the negative battery terminal. Then, raise the vehicle and remove the under-vehicle splash shield. Drain the cooling system and detach the radiator hoses. Disconnect the overflow hose and remove the condenser-to-radiator mounting bolts. Take out the cooling fans and radiator support brackets. Disconnect the oil cooler hose and transmission cooler lines, if equipped. Use a quick disconnect tool to disconnect the transmission cooler lines. On ZL1 models, unclip the supercharger hose. Carefully lift out the radiator, being careful not to spill coolant or scratch the paint. Clean the radiator and inspect it for leaks or damage. If needed, have it repaired by a professional. To install the radiator, inspect the rubber insulators in the lower crossmember and make sure they're clean and in good condition. Seat the radiator correctly on the insulators and fasten the top brackets. Fill the cooling system with the correct mixture of antifreeze and water. Start the engine, check for leaks, and add more coolant if necessary. If working on an automatic transmission-equipped vehicle, check and add fluid as needed. For ZL1 models, follow the specific removal and installation steps for the charge air cooler radiator, which is a separate system from the engine cooling system.