Genuine Chevrolet C1500 Spark Plug

Chevrolet C1500 Spark Plug Parts Questions & Experts Answers

• Spark Plug Asm
  19302741
  Q: How to replace spark plugs?

  A: To avoid misplacing the wires, after opening the hood, start by labeling each spark plug wire to ensure you place them correctly during the reinstallation of new spark plugs. Several tools are needed to do this job such as a spark plug socket with a padded interior to prevent porcelain insulators of new plugs from being damaged, pipe extensions of various dimensions, gap gauge for checking and adjusting plug gaps and a torque wrench used in tightening the new plugs. It is advisable to purchase new spark plugs ahead of time with set gaps that can be adjusted to meet specifications as well as replacing them one at a time. You should give your engine enough time to cool before removing any plugs, during this period scrutinize the new plugs for faults and adjust their gaps if needed. Checking the gap will entail using a wire-type gauge to make sure that there is a slight drag when sliding it between electrodes so that it matches up with the emissions control information label specified gap. This adjustment is done by bending slightly side electrode without breaking off or damaging porcelain insulation. When engine is cold remove one spark plug wire from one plug using preferably plug wire removal tool blow clean any dirt or debris around the spark plug hole through compressed air or bicycle pump so as not to contaminate it. Use a Spark plug socket with a short handle in order to unscrew the plug counter clockwise. Examine removed plug for signs of how the engine has been running since it was last replaced. Insert one of the new plugs into the hole screw it in finger tight then finally use torque wrench or ratchet on it. Rubber hose should be used threaded for threading instead cross-threading taking place.Threaded rubber hose can be used to thread into, preventing cross threading.Before connecting wire from a hot ignition coil onto another spark-plug check out whether there are any defects in those wires and finally repeat such operation regarding remaining spark-plugs; replace each one individually so as not mix up the wires.