My Garage
My Account
Cart
Genuine Buick Enclave Oil Pump
Oil Fluid Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Oil Pumps found
Buick Enclave Pump,Oil
Part Number: 12640448$140.06 MSRP: $243.75You Save: $103.69 (43%)Ships in 1-2 Business Days
Buick Enclave Pump Assembly, A/Trns Fluid (W/O Filter & Drvtrn)
Part Number: 24042244$240.77 MSRP: $380.46You Save: $139.69 (37%)Ships in 1-2 Business Days
Buick Enclave Oil Pump
The Oil Pump in Buick Enclave vehicles is one of the most important parts of the internal combustion engine since it circulates oil under pressure to lubricate and cool components of the engine. This pump is made of gears and springs and gasket products that help in circulatory distribution of oil around the engine and bearings and piston. Stuff and trochoid kind of oil pumps are used in several Enclave models, whereas mechanical type of pumps are favored for being more reliable. Ideal oil pressure is about 10psi per 1000 RPM and it is critical to the engine as well as it's performance and durability, potent engines may require more effective lubrication system like a dry sump system complete with multiple pumps. It is recommended to go for a routine check-up especially the oil and the filter change in order to avoid accumulation of dirt and to make sure the oil pump is running in the Buick Enclave vehicles.
Each OEM Buick Enclave Oil Pump we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Buick Enclave Oil Pump Parts Questions & Experts Answers
- Q: How to remove and reinstall the oil pump in an engine?A: Remove the Timing Chains. After noting the installed position, remove the timing chain sprocket from the crankshaft. Remove the oil pump retaining bolts and slide the pump off the end of the crankshaft (Oil pump retaining bolts). Remove the timing chain guide from the oil pump housing then remove the oil pump cover and withdraw the rotors from the pump body. Remove the snap-ring from the side of the pump housing and withdraw the cap, spring and plunger from the oil pump housing. These components are the oil pressure relief valve assembly. Clean the components with solvent, dry them thoroughly and inspect for any obvious damage. Also check the bolt holes for damaged threads and the splined surfaces on the crankshaft sprocket for any apparent damage. If any of the components are scored, scratched or worn, replace the entire oil pump assembly. There are no serviceable parts currently available. If re-using the oil pump, assemble the pressure relief valve components and the rotors to the oil pump housing. Prior to installing the cover, prime the pump by pouring clean motor oil between the rotors. Install the cover and tighten the retaining bolts. Position the oil pump over the end of the crankshaft and align the flats on the crankshaft with the flats on the oil pump drive gear. Make sure the pump is fully seated against the block. Install the oil pump mounting bolts and tighten them to the torque. The remainder of installation is the reverse of removal. Add oil and coolant as necessary. Run the engine and check for oil and coolant leaks. Check the oil pressure.
