How to replace the knock sensor on a Buick Enclave,Chevrolet Traverse and GMC Acadia?

Lift the vehicle and secure on jackstands. For the rear cylinder bank (Bank 1), remove the engine block heat shield. For the front cylinder bank (Bank 2), remove the oil filter. On 2009+ models, remove the catalytic converter to access Bank 2 sensor. Disconnect the knock sensor connector and remove the retaining bolt. Unscrew the bolt and remove the sensor. To install, reverse these steps and tighten the bolt to the specified torque.

Genuine Buick Enclave Knock Sensor

Engine Knock Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Knock Sensors found

View related parts
Buick Enclave Sensor Assembly, Knock
Part Number: 12636736
$18.32 MSRP: $34.56
You Save: $16.24 (47%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: SENSOR, Distributor (also Knock Sensor); Camshaft Sensor, Knock Sensor
- Replaced by: 12729597
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2009-2021 Buick Enclave | BASE EXTENDED 4 DOOR SUV, PREMIUM 1 EXTENDED 4 DOOR SUV, PREMIUM 2 EXTENDED 4 DOOR SUV, SPORT UTILITY VEHICLE 2WD, SPORT UTILITY VEHICLE 4WD, SPORT UTILITY VEHICLE AWD | 6 Cyl 3.6L
View related parts
Buick Enclave Sensor Assembly, Knock
Part Number: 12618603
$36.90 MSRP: $69.61
You Save: $32.71 (47%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: SENSOR, Distributor (also Knock Sensor); Knock Sensor
- Replaces: 12566845
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2008 Buick Enclave | SPORT UTILITY VEHICLE 2WD, SPORT UTILITY VEHICLE AWD | 6 Cyl 3.6L

Buick Enclave Knock Sensor Parts Questions & Experts Answers

Sensor Assembly, Knock
12636736
Q: How to replace the knock sensor on a Buick Enclave,Chevrolet Traverse and GMC Acadia?
A: Lift the vehicle and secure on jackstands. For the rear cylinder bank (Bank 1), remove the engine block heat shield. For the front cylinder bank (Bank 2), remove the oil filter. On 2009+ models, remove the Catalytic Converter to access Bank 2 sensor. Disconnect the knock sensor connector and remove the retaining bolt. Unscrew the bolt and remove the sensor. To install, reverse these steps and tighten the bolt to the specified torque.