Pontiac 20301183 Arm Asm

You can Select Your Vehicle to check if 20301183 fits your vehicle.

Intense heat from the sun, snow and ice, road oils and windshield washer solvents can cause rubber wiper refills to deteriorate. It is recommended to replace the refills twice a year or when streaking or chattering occurs. To maintain effectiveness and prolong element life, keep the windshield and wiper blades clean by washing with a glass cleaner and wiping the rubber blades. Avoid moving the wipers by hand to prevent damage. To inspect or replace the wiper blade elements, place the wiper switch in LOW speed and the ignition switch in ACC position. When the blades are vertical, turn the ignition switch OFF. Cracked, broken, or torn elements should be replaced immediately. Replacement intervals vary, but ozone deterioration limits element life to about one year. If the wiper pattern is smeared, streaked, or chattering, replace the elements in pairs. Aftermarket blades may require different types of refills. Anco® refills have a release button, Trico® refills can be removed by pressing down on the metal backing strip, and other Trico® refills have two metal tabs that need to be squeezed together. Polycarbonate refills have a locking device, and Tridon® refills require removing the wiper blade by twisting counterclockwise. Follow the manufacturer's instructions closely and ensure all frame jaws are engaged to avoid scratching the glass during wiper operation.

Removal of the wiper arms requires the use of a special tool, G.M. J-8966 or equivalent, which is generally available in auto parts stores. Insert the tool or a screwdriver under the wiper arm and pry the arm off the shaft, being careful not to scratch the paint. Disconnect the Washer Pump hose from the arm (if so equipped) and remove the arm. To install, position the arm over the shaft and press down, making sure to install the arms in the same position on the windshield as they were when they were removed. Raising the hood on most later models will facilitate easier wiper arm removal.

G.M. J-8966 or equivalent, which is generally available in auto parts stores.

Lift the wiper arm from the window, then insert the tool under the wiper arm and lever the arm off the transmission drive shaft.

The drive from the wiper motor to the wiper arms is achieved through a crank arm and a strut to the transmission shafts.

Check the alignment of the arm.

Start by disconnecting the negative battery cable and removing the instrument cluster trim panel. Then, remove the switch from the rear by taking out the 2 mounting screws.