Oldsmobile 12450057 Flasher,Hazard Lamp & Turn Signal Lamp

You can Select Your Vehicle to check if 12450057 fits your vehicle.

The flasher for the turn signals is a small canister-shaped unit positioned under the dash beneath the knee bolster or behind the glove compartment on vehicles made in 1999 and after. It sits next to a huge wiring splice and is held by plastic strap. When it works, there should be an audible click sound accompanying its operations. Where one side's turn signals fail without that characteristic clicking noise of the flasher, then a busted signal bulb exists. In case both stop lights stay on without blinking, this could be due to a blown fuse, a faulty flasher unit, a broken switch or loose or open connections. To replace flasher relay remove under-dash panel or knee bolster so as to unplug it from its socket. A new one must match the old in all regards. The hazard warning lamp assembly used for flashing all four turn signal lamps at once upon switching it on is situated inside instrument panel behind knee bolster or behind glove compartment on 1999 and later models too. It also abuts against large wire clamp and is held in place with plastic band. Checking procedure for hazard warning light unit resembles that of turn indicator unit described above. To replace it you will need to take off under-dash panel or knee bolster cover in order to unplug the flasher itself. The replacement lamp has to be exactly similar to the one being replaced.

To remove the switch of the turn signal, first of all disconnect the negative battery cable, then remove steering column covers and driver's knee bolster. Afterwards, remove the top two Torx screws securing a multi-function switch to a steering column. After that unclip the wire ties that secure it in place on other wires of the steering column. At the bottom of the steering column firewall bulkhead remove bolt holding large connections. Separate two multi-function switch connectors from large bulkhead connector. Remember that Multi-Function Switch and its harness should be replaced together as one unit. To install new switch just reverse removal process steps.

Separate the two multi-function switch connectors from the large bulkhead connector.

These relays are typically grouped together in various locations, including the engine compartment.

Separate the two multi-function switch connectors from the large bulkhead connector.

These relays are typically grouped together in various locations, including the engine compartment.

Several electrical accessories in a vehicle rely on relays to transmit electrical signals to their respective components.

Unclip the wire ties that secure the multi-function switch harness to the other steering column wires.

To replace the hazard flasher, the under-dash panel or knee bolster needs to be removed for access and the flasher needs to be unplugged. The replacement unit should be identical to the one it replaces.

To replace the turn signal flasher, the under-dash panel or knee bolster needs to be removed and the flasher needs to be unplugged. The replacement unit should be identical to the original.

These relays are typically grouped together in various locations, including the engine compartment.

The hazard flasher is located in the instrument panel behind the knee bolster or behind the glove compartment on 1999 and later models.