GMC 18060242 Front Brake Rotor Assembly

You can Select Your Vehicle to check if 18060242 fits your vehicle.

Raise the car, support it with jack stands, and remove the wheel and tire assembly. Remove the brake caliper, and support with wire. Remove the dust cap and remove the cotter pin and the bearing retaining nut. Remove the outer wheel bearing and place it in a clean location. Remove the wheel bearing, hub, and disc assembly from the spindle. Installation is in the reverse order of removal. Check the disc for any obvious defects such as excessive rust, chipping, or deep scoring. Make sure there is no wheel bearing play by performing the wheel bearing adjustment procedure. Then, check the disc for run-out by installing a dial indicator on the caliper so that its feeler will contact the disc about one inch below its outer edge. Turn the disc and observe the run-out reading. If the reading exceeds 0.002 in. (0.05mm), replace the disc. Check the caliper thickness with a vernier caliper or other appropriate tool. Minimum thickness dimensions are cast into the disc. Adjust the wheel bearings.

To inspect the brakes, begin by loosening wheel lug nuts and raising the front of the vehicle on jack stands. Take off the wheel followed by the brake caliper. While checking for any score marks or damage on disc surfaces, remember that slight scratches and shallow grooves are normal and will not affect the brake operation. Nevertheless, deep grooves of over 0.015-inch deep necessitate disc removal and refinishing at a machine shop. Make sure both sides have been inspected thoroughly. When inspecting a rear disc, reinstall wheel lug nuts with flat side towards disc to hold it in a flat vertical plane during inspection. Washers may be needed under lug nuts to apply pressure to disc. To check for disc runout, place dial indicator about 1/2 inch from outer edge of disc and zero it out. Turn disk around while making sure that reading does not exceed 0.003 inches on indicator gauge; if it does so, then let machine shop refinish disk for you.Additionally don't allow multiple groves on your brake rotors which should be well maintained as long as they don't wear below specified minimum thickness.It is also possible to measure rotor thickness with micrometer.For removal and installation, on 2WD models, the disk is part of the front hub assembly and should be removed and installed according to front wheel bearing maintenance procedure.On 4WD models remove tire; remove caliper , then pull off disk from its mounting onto hub.

Check for any score marks or damage. Keep in mind that light scratches and shallow grooves are normal and won't affect brake operation. However, deep grooves over 0.015-inch deep will require disc removal and refinishing by a machine shop.

Start by loosening the wheel lug nuts and raising the front of the vehicle on jack stands. Remove the wheel and then the brake caliper.

Reinstall the wheel lug nuts with the flat side towards the disc to hold it in a flat, vertical plane during the inspection. You may need to use washers under the lug nuts to apply pressure to the disc.