GMC 12559516 Pan,Oil

You can Select Your Vehicle to check if 12559516 fits your vehicle.

In order to remove and install the oil pan, the procedure is different for each model year as well as the drivetrain. To start with 1994 and 1995 4WD models, you should disconnect negative battery cable and drain oil. Starter motor needs to be removed as well as two engine-to-bellhousing braces and lower part of bellhousing cover. Exhaust pipes must be separated from the manifolds. Oil pan mounting bolts/nuts are removed carefully noting location of studs and brackets. Slowly separate pan from block without prying so as not to damage sealing surfaces. Sealing surface distortion on oil pan flange can also be checked if any. New gasket is attached to pan with RTV sealant applied after cleaning gasket surfaces and carefully positioning it against block. Bolts/nuts are tightened in three steps starting at center and following a spiral pattern outwards. Engine removal may be needed for 2WD models (especially those with cast-aluminum oil pans) while 4WD models can use raised engine, which could mean that they will need to remove the engine first before accessing it fully in case there is a cast-aluminum oil pan involved. After removing bolts separate the pan carefully without using a pry tool, clean gasket surfaces, apply RTV sealant. Aligning the pan properly with the block, checking clearances when necessary then tightening of the bolts/studs holding it down in sequence. Complete remaining steps in reverse order; start engine; check for leakages at the pan before engaging gear.

If the oil pan is stuck, it can be dislodged using a block of wood and a hammer.

When separating the oil pan from the block, it's recommended to do so carefully without prying to avoid damaging sealing surfaces. This method helps maintain the integrity of the gasket surfaces.

After removing the oil pan bolts, the oil pan should be separated carefully, and the gasket surfaces should be cleaned.

The initial steps involve disconnecting the negative battery cable, draining the oil, and removing the starter motor, two engine-to-bellhousing braces, and the lower part of the bellhousing cover.

The oil pan should be installed and the mounting bolts should be tightened. It is recommended to start at the center of the pan and work out toward the ends in a spiral pattern.

A 3/16-inch wide by 1/8-inch thick bead of RTV sealant should be applied around the oil pan flange and the front circle of the pan, where it contacts the timing chain cover.

Before removing the fasteners, it is advised to make a mark on the pan to indicate their location for reassembly.