GMC 15052597 Cable Assembly, Parking Brake Rear

You can Select Your Vehicle to check if 15052597 fits your vehicle.

You can let go of the parking brake by unfastening the lugnuts on your back wheel in case you want to remove a rear cable first. After that, lift the vehicle and put it in place using jack stands before taking out its tire. To relieve pressure from the front cable, try loosening the adjusting nut. Next, remove the parking brake pedal assembly from the kick panel and pull out a plug at one end of the cord from an aperture in a ratchet cam. Squash down on two prongs near the rope socket and draw it through its bracket. Disengage forward one for front cables from connector located behind equalizer under vehicle . The reverse of removal is installation so have this mind when you are done with everything else never forget that you need to adjust cable. For left rear cable, if necessary release cable adjusting nut and disengage front end of cable from connector. Pinch together the fingers of ferrule which holds the wire at free end equalizer and slide out strung cord through it. Unscrew adjuster nut completely on right rear cable then disengage this string from equalizer Remove loose nuts holding clamp around right side of steering system Squeeze finger on ferrule griping wire channel then slip string over its holder or bracket Find this hose back along right rear wheel's side until it clips onto differential Disconnect parking brake lever from drum type shoes fitted into backing plate by removing their bolts While disconnecting park brake cables other than levered ones Rear brakes should be returned into initial shape including making use of adjusted new pads.

To release the parking brake, start by loosening the rear wheel lugnuts if you're removing a rear cable. Then, raise the vehicle and secure it on jack stands before removing the wheel. For the front cable, you may need to back off the adjusting nut to release tension. Detach the parking brake pedal assembly from the kick panel and pull the plug on the end of the cable out of its hole in the ratcheting cam. Squeeze the tangs on the parking brake cable ferrule and slip the cable through its bracket. Underneath the vehicle, disengage the front cable from the connector located forward of the equalizer. The installation is the reverse of removal, and don't forget to adjust the cable when you're done.