GM 25201063 Turbocharger Asm

You can Select Your Vehicle to check if 25201063 fits your vehicle.

The steps to remove the turbocharger/exhaust manifold assembly are as follows:1. Drain the engine coolant.2. Remove the air filter housing outlet duct.3. Detach the PCV hose from the turbocharger.4. Remove the turbocharger heat shield (Heat shield mounting bolts).5. Disconnect the electrical connector from the turbocharger wastegate regulator solenoid valve.6. Detach the wiring harness from its retaining clip.7. Place a drain pan under the engine.8. Remove the turbocharger oil feed pipe banjo bolt, along with the sealing rings.9. Disconnect the oil feed pipe from the turbocharger.10. Remove the turbocharger oil feed pipe-to-block bolt, then remove the pipe and gaskets.11. Remove the turbocharger coolant return pipe and gasket.12. While holding the coolant feed pipe from turning, remove the coolant feed pipe banjo bolt, feed pipe, and gaskets.13. Detach the charge air cooler inlet pipe from the turbocharger.14. Remove the catalytic converter.15. Remove the oil return pipe bolts from the bottom of the turbocharger and separate the pipe flange from the turbocharger.16. Lower the vehicle and unbolt the turbocharger/exhaust manifold mounting nuts in reverse order of the tightening sequence.17. On 2016 and later models, there is no exhaust manifold, the turbocharger bolts directly to the cylinder head, and the exhaust manifold is integral to the cylinder head.18. Remove the turbocharger and gasket from the cylinder head.19. On 2016 and later models, the turbocharger gasket has been combined with a heat shield and must be replaced as an assembly.20. Install a new gasket over the studs, and then install the turbocharger/exhaust manifold on the studs.21. Install new mounting nuts and tighten the nuts in sequence.22. The remainder of the installation is the reverse of removal.23. Use new sealing washers and tighten the oil and coolant line bolt.24. Refill the cooling system and change the engine oil and filter.

Yes