GM 19301075 Front Suspension Strut

You can Select Your Vehicle to check if 19301075 fits your vehicle.

To remove the rear shock absorbers, you start by loosening the lug nuts on the rear wheels and then block the front wheels to stop the vehicle from rolling; raise its back with jackstands being used for support. Once securely raised, remove your car's rear wheels. Next, place a jack under the rear knuckle where it connects to the lower control arm and lift it a little to relieve tension on coil spring. After that, you can remove its lower shock absorber fastener from the rear knuckle. Support and take off shock fasteners which connect it to body while removing shock absorber. After that, install new shock absorbers by reversing removed steps whereas bolts should be tightened as per their specified torque.

Extend the damper rod and install the rubber bump stop and dust boot. Place the compressed coil spring onto the lower seat of the damper, with the end of the spring against the raised stop.

Start by loosening the wheel lug nuts and raising the vehicle on jackstands.