GM 15617145 Pedal And Lever Package, Brake

You can Select Your Vehicle to check if 15617145 fits your vehicle.

Onne must begin by disconnection the cord from the negative pole of the battery to take off the pedal break for 1993 and later models. In case it is necessary, remove driver side knee bolster. Subsequently, remove brake light switch and master cylinder pushrod from brake pedal. Check up on bushings and spacers' positions, then proceed by removing nut and pivot bolt at top of pedal arm. As soon as you remove those two nuts and bolts, it is easy to separate entire pedal arm from its bracket at which point you can get your spacer or even bushing back. If any one part appears overly worn out or damaged following an examination of all components, make sure it's replaced with a new one.To install brake pedal, fix these bushes along with spacers in their right locations on pedal arm before positioning pedal arm onto mounting bracket securing with pivot bolt and finally tightening nut well.After that follow reverse steps for reinstallation.

To remove the brake pedal on 1993 and later models, start by disconnecting the cable from the negative terminal of the battery. If needed, remove the driver's side knee bolster. Then, take out the brake light switch and master cylinder pushrod from the brake pedal. Check the position of the bushings and spacers, and proceed to remove the nut and pivot bolt located at the top of the pedal arm. Once the nut and bolt are removed, withdraw the pedal arm from the mounting bracket and retrieve the spacers and bushings. Inspect all components for excessive wear or damage and replace if necessary.