GM 25906094 Hose Assembly, Rear Brake

You can Select Your Vehicle to check if 25906094 fits your vehicle.

When replacing flexible hoses, it is important to clean the ends of the hose and disconnect the brake line from the hose fitting, being careful not to bend the frame bracket or line. The U-clip should be removed from the female fitting at the bracket and the hose should be removed from the bracket. Any mounting fasteners for brackets that secure the hose to other components should be removed, and on models where the hose is connected directly to the caliper, the hose fitting should be disconnected from the caliper by removing the banjo bolt. The copper washers on both sides of the fitting should be discarded and new copper washers should be used to attach the new brake hose to the caliper. The hose should be routed exactly as the original one was and any hose brackets that secure the hose to other components should be mounted, as equipped. The female fitting should be passed through the frame or frame bracket and installed in position with the least amount of twist in the hose. The U-clip should be installed in the female fitting at the frame bracket and the brake line should be attached to the hose fitting using a backup wrench on the fitting. The tube nut should be tightened securely and the replacement hose should follow the same path as the original one to avoid contact with moving suspension or steering components. Finally, the brake lines should be bled. When replacing metal brake lines, it is important to use the correct parts and not use copper tubing for any brake system components. Prefabricated brake lines, with the ends already flared and fittings installed, should be used and carefully bent to the proper shape if necessary using a tube bender. The new line should be well supported in the brackets and have plenty of clearance between moving or hot components. After installation, the brake fluid reservoir level should be checked and fluid added as necessary. The brake system should be bled and the brakes should be confirmed to be fully operational before resuming normal driving.

To replace a flexible hose in the brake system, follow these steps:Clean any dirt from the ends of the hose.

To install the new brake hose, follow these steps: Route the hose exactly as the original one was. Mount any hose brackets that secure the hose to other components, as equipped. Pass the female fitting through the frame or frame bracket and install it in position with the least amount of twist in the hose. Install the U-clip in the female fitting at the frame bracket. Attach the brake line to the hose fitting using a backup wrench on the fitting. Tighten the tube nut securely.

The initial steps to replace flexible hoses in the brake system are as follows: Clean the ends of the hose. Disconnect the brake line from the hose fitting, being careful not to bend the frame bracket or line. Remove the U-clip from the female fitting at the bracket and remove the hose from the bracket. Remove any mounting fasteners for brackets that secure the hose to other components. On models where the hose is connected directly to the caliper, disconnect the hose fitting from the caliper by removing the banjo bolt. Discard the copper washers on both sides of the fitting and use new copper washers to attach the new brake hose to the caliper.

The initial steps to replace flexible hoses in the brake system are as follows: Clean the ends of the hose. Disconnect the brake line from the hose fitting, being careful not to bend the frame bracket or line. Remove the U-clip from the female fitting at the bracket and remove the hose from the bracket. Remove any mounting fasteners for brackets that secure the hose to other components. On models where the hose is connected directly to the caliper, disconnect the hose fitting from the caliper by removing the banjo bolt. Discard the copper washers on both sides of the fitting and use new copper washers to attach the new brake hose to the caliper.