GM 12703806 Camshaft Assembly, Overhead Vlv

You can Select Your Vehicle to check if 12703806 fits your vehicle.

Before installing the camshaft, you should lubricate the camshaft bearing journals and lobes with assembly lube.

The measurement for cam lobe lift should be taken by slowly turning the engine until the pushrod is at its lowest point (base circle of the camshaft lobe), then zeroing the dial indicator. The crankshaft is then rotated in the normal direction until the indicator needle reaches its peak and begins moving in the opposite direction, marking maximum cam lobe lift. This measurement is important to assess camshaft wear.

The initial steps to remove the camshaft are disconnecting the cable from the negative battery terminal and relieving the fuel system pressure.

To check for a noisy valve lifter, you can use a mechanics stethoscope or a length of hose near each valve while listening for excessive clearance in the valvetrain. If a lifter is defective, it will be evident from the noise.

The steps for installing the camshaft are as follows:1. Lubricate the camshaft bearing journals and cam lobes with assembly lube.2. Slide the camshaft into the engine.3. Install the camshaft thrust plate.4. Install the balance shaft drive gear.5. Install the timing chain and sprockets.6. Lubricate the lifters with clean engine oil.7. Install the lifters in the block.8. Complete the installation in reverse order of removal.

After installing the camshaft, proceed to install the balance shaft drive gear, aligning the dowel pin and ensuring proper alignment of the balance shaft timing marks. Then, install the timing chain and sprockets.

The steps to remove the camshaft are as follows:1. Remove the intake manifold.2. Remove the rocker arms.3. Remove the pushrods.4. Remove the timing chain.5. Remove the camshaft sprocket.6. Remove the balance shaft drive gear.7. Remove the fan, radiator, and condenser.8. Store the lifters in a labeled box.9. Remove the lifter retainer.10. Extract the lifters from the bores using a special tool, magnet, or your fingers.11. Remove the camshaft retainer plate.12. Use three 6-inch long, 5/16-18 bolts as a handle to remove the camshaft from the block.

After installing the camshaft, the cooling system should be refilled, the oil should be changed, and a new oil filter should be installed before starting and running the engine.

Proper labeling and storage of the lifters are essential to ensure that they are returned to their original locations during reinstallation, preventing any mix-up.

If the lobes are in good condition and the measurements are as specified, the camshaft can be reused.