Chevrolet 19168519 Fuel Tank Meter/Pump SENSOR KIT

You can Select Your Vehicle to check if 19168519 fits your vehicle.

To remove the fuel pump/Fuel Level Sensor, start by disconnecting the cable from the negative battery terminal. Then, relieve the system fuel pressure and equalize tank pressure by removing the fuel filler cap. Next, remove the fuel tank and disconnect the fuel supply and return lines from the fuel pump/Fuel Level Sensor module, being careful to soak up any spilled fuel. Mark the orientation of the fuel pump in relation to the fuel tank for proper realignment during installation. Use water pump pliers to unscrew the locknut counterclockwise, or use a hammer and brass punch if it's tight. Remove the fuel pump/Fuel Level Sensor, taking care not to damage the fuel inlet strainer or the Fuel Level Sensor float arm and float. For installation, inspect and replace the pump-to-tank seal if necessary, and ensure the fuel pump inlet strainer is clean. Carefully align and insert the fuel pump/Fuel Level Sensor module into the tank, avoiding damage to the strainer, float arm, or float. Finally, reconnect the battery and allow the Powertrain Control Module (PCM) to relearn its former driveability and performance characteristics.

Slide the fuel level sensor unit back into place until you hear a click, ensuring that the float arm is correctly aligned.