Chevrolet 13579564 Front Side Door Latch Assembly

You can Select Your Vehicle to check if 13579564 fits your vehicle.

The Door Latch Assembly and window regulator module can be done away with through unplugging the electrical connector and removing the rods since they follow a modular design. For one, the bolt cover, just like the lock trim cover, can be removed to get rid of the outside handle; or a hooked tool can be used to keep the bellcrank lever at half open position during the handle's removal. To take out this lock, press and free it from its holding frame while separating its bar and stripping it off from the tie bar. The inside door handle is detached after taking off its panel by opening screws of materials that surround it using screws or other mechanical fasteners including nuts or bolts which are then disconnected from each other through disconnecting rods attached on metallic parts of their surfaces or ends.

If you encounter issues with the power door lock system, you can perform various diagnostic steps, including checking wiring connections, actuators, and circuit protection. If troubleshooting steps do not identify the issue, it is recommended to consult a dealer service department for further assistance.

A few drops of light oil or lock lubricant.

The inside door handle can be removed by removing the door trim panel and plastic watershield, then removing the mounting screws and detaching the handle assembly from the door. Finally, disconnect the rods and electrical connector, and remove the assembly.

The power door lock system operates through switches, actuators, and the BCM. The lock switches send a signal to the BCM, which then sends a signal to the door lock solenoids to control the door locks.

Once every 3000 miles or every three months.

Yes