Chevrolet 15735411 Cable Assembly, Accelerator Control

You can Select Your Vehicle to check if 15735411 fits your vehicle.

Disconnect the cable from the negative battery terminal. Caution: On models equipped with the Theftlock audio system, be sure the lockout feature is turned off before performing any procedure which requires disconnecting the battery. Access the throttle body by removing the air filter assembly from the TBI unit on TBI systems, or by removing the air intake duct and resonator from the throttle body on Central SFI and MPFI systems. Detach the cruise control cable from the throttle lever, if equipped. Rotate the throttle lever and separate the throttle cable end from the throttle lever by passing the cable through the slot in the throttle lever. Depress the locking tabs on the cable housing and push the cable housing through the bracket, then detach the cable from the cable routing retainers. Remove the trim panel from under the dash and detach the cable from the accelerator pedal by pulling the accelerator cable retainer out of the pedal and sliding the cable through the slot. Depress the locking tabs on the cable housing and push the cable through the firewall and into the engine compartment. Finally, remove the cable from the engine compartment. Installation is the reverse of removal.

First, remove the air cleaner. Then, detach the cable terminal from the throttle lever and detach the housing from the bracket. Remove the routing clips or straps. Trace the cable to the transmission and remove the bolt and flat washer. Disconnect the cable from the transmission link and remove the seal. Installation is the reverse of removal.

Rotate the throttle lever and pass the cable through the slot in the throttle lever.

The TV cable controls line pressure, shift feel, shift points, detent downshifts, and part throttle downshifts.