Buick 26100287 Rod Kit,Steering Linkage Outer Tie

You can Select Your Vehicle to check if 26100287 fits your vehicle.

To remove the tie-rod end, start by loosening the wheel lug nuts and raising the front of the vehicle. Support it securely on jackstands and apply the parking brake. Block the rear wheels to prevent the vehicle from rolling. Remove the wheel and measure the length of exposed threads on the tie-rod end. Write down this measurement and then break loose the tie-rod end jam nut. Loosen the nut on the tie-rod end ball stud, but do not remove it. Use a puller to break loose the tie-rod end from the steering knuckle arm. Remove the nut and detach the tie rod end from the steering knuckle. Unscrew the tie rod end from the tie rod. To install the new tie-rod end, thread the new jam nut onto it so that the same length of threads is exposed. Connect the tie-rod end to the steering knuckle arm and install the nut on the ball stud. Tighten it to the specified torque. Securely tighten the jam nut and install the wheel. Lower the vehicle and tighten the lug nuts to the specified torque. Finally, have the front-end alignment checked and adjusted if necessary.

Unscrew the tie rod end from the tie rod.

88982342 L LINK KIT, RR STAB SHF - LH (Service Lane Part) ST155 2002-2005 01 102.58 4F 1550C 88982343 R LINK KIT, RR STAB SHF - RH (Service Lane Part) ST155 2002-2005 01 102.58 4F 1550C 26100288 ROD KIT, STRG LNKG INR TIE (16MM X 1.5) (W/GEARS STAMPED 15162147,15185191, 15217081) (Service Lane Part) ST1 NON-VARIABLE P/S (N40) 2003-2009 02 162.53 9D X0038 26100286 L ROD KIT, STRG LNKG OTR TIE (16MM THREADS ON GEAR END) - LH (Service Lane Part) ST1 NON-VARIABLE P/S (N40) 2003-2004 01 215.33 9D X0039 26100287 R ROD KIT, STRG LNKG OTR TIE (16MM THREADS ON GEAR END) - RH (Service Lane Part) ST1 NON-VARIABLE P/S (N40) 2003-2004 01 215.33 9D X0039 28 89059275 04.563 ACTUATOR, TRFER CASE FOUR WHL DRV (INCLS 29,30) (INCLS MOTOR ENCODER) (ACDelco #89059275) (Service Lane Part) T155 (EXC NP4) 2002 - 2003 01 7E 3A X0102