Raise the vehicle and support it securely on jackstands, then insert a large screwdriver or prybar between the mount and the transaxle to pry up. Ensure the transaxle does not move excessively away from the mount; if it does, replace the mount. For the left-end mount, raise the vehicle and support it securely on jackstands, then remove the through-bolts from the front and rear transaxle mounts while supporting the engine from below with a floor jack and a block of wood. Remove the battery, battery tray, and tray support, then disconnect the right and left upper engine mounts. Use the jack to lower the engine enough to allow for mount removal, then unbolt the left transaxle mount from the left frame, with installation being the reverse of removal. For the side mounts, with the engine/transaxle supported by a jack and a block of wood, remove the nuts and bolts to take off the mount, moving the transaxle slightly if necessary for clearance. Installation is the reverse of removal, ensuring all mount fasteners are installed before tightening any of them.