Genuine Saturn Ion Oil Filter

Saturn Ion Oil Filter Parts Questions & Experts Answers

• Filter Assembly, Oil (Cap W/Filter & Seal)
  12605565
  Q: How to changing the oil and Oil Filter in a Chevrolet Cobalt,HHR and Saturn ION?

  A: Vehicles equipped with an oil life indicator system illuminate a light or message on the instrument panel to signal the need for an oil change, typically allowing for extended intervals compared to the traditional 3000-mile mark, but it's recommended not to exceed 10,000 miles between changes. Frequent oil changes are crucial for preventive maintenance as aging engine oil becomes diluted and contaminated, contributing to premature engine wear. Before initiating the oil change, ensure you have the necessary tools and ample rags or newspapers for oil spills. Access to the oil drain plug and filter is improved when the vehicle is raised on a hoist, driven onto ramps, or supported by jackstands. Start the engine and let it reach normal operating temperature, facilitating easier oil drainage. Park on a level surface, shut off the engine, and remove the oil filler cap. Raise the vehicle, supporting it securely with jackstands. Carefully position a drain pan beneath the engine's drain plug, remove the plug with a proper-sized wrench, and be cautious of hot exhaust components. After draining, inspect the old oil for metal particles, clean the drain plug, and the surrounding area, then reinstall and tighten it. Move the drain pan under the oil filter, unscrew the filter cap, and remove both the cap and element. Clean the housing and cap thoroughly. Install a new O-ring seal and a new filter element into the cap, then insert them into the filter housing, securely tightening the cap. Lower the vehicle, add fresh oil through the filler cap using a funnel, and check the oil level with the dipstick. Start the engine for a minute, inspect for oil leaks, and recheck the dipstick. During initial trips after the oil change, monitor for leaks and proper oil levels. Properly dispose of the old oil by checking with local facilities or recycling centers. Lastly, reset the "Change Engine Oil" light using either of the two specified methods, depending on your vehicle's features, ensuring the Oil Life Monitor is successfully reset.