My Garage
My Account
Cart
Genuine Saturn Ion Clutch Master Cylinder
- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Clutch Master Cylinder found
Saturn Ion Clutch Master Cylinder
The Clutch Master Cylinder SATURN ION Auto Spare Parts is crucial in the making of hydraulic pressure for Clutch in manual transmission. When the driver actuates the clutch pedal, hydraulically, fluid from the master cylinder moves to the slave cylinder that reduces the pressure from the clutch release bearing allowing the clutch to unlock from the flywheel. This hydraulic mechanism is used to control the gear shifting process and the dramatics of the whole transmission. Such signs as leakage of fluids, low consistency of the pedal, or a problem associated with shifting and suggest that the Clutch Master Cylinder is faulty. Problems such as these are usually due to worn seal or cylinder bores either letting air into the system or moisture into the hydraulic fluid and rust. Sustaining the Clutch Master Cylinder is very important for the general functioning of the transmission system of the vehicle.
Each OEM Saturn Ion Clutch Master Cylinder we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Saturn Ion Clutch Master Cylinder Parts Questions & Experts Answers
- Q: How do I remove and install a clutch master cylinder?A: To remove the clutch master cylinder, start by pulling the plastic clip near the top of the clutch pedal under the dash on the driver's side. This will disengage the pedal. Next, remove as much fluid as possible from the brake master cylinder reservoir using a syringe or turkey baster. Place rags under the fluid fittings and prepare caps or plastic bags to cover the ends of lines or fittings once they are disconnected. Disconnect the negative battery cable and unbolt the underhood electrical center, setting it aside. Disconnect the fluid feed hose from the clutch master cylinder and plug it to prevent spilling brake fluid. Remove the line clip at the master cylinder hydraulic line fitting and separate the hydraulic line from the cylinder. Finally, twist the master cylinder 90 degrees clockwise and remove it from the vehicle. To install the clutch master cylinder, place the master cylinder pushrod through the firewall and twist the master cylinder 90 degrees counterclockwise to secure it, ensuring the pushrod is aligned with the clutch pedal. Push the clutch pedal down to engage the pushrod and reinsert the plastic clip. Attach the fluid feed hose to the clutch master cylinder and connect the hydraulic line fitting, securing it with the retaining clip. Fill the reservoir with DOT 3 brake fluid and bleed the clutch system. Additionally, check the feel of the brake pedal and bleed the brake hydraulic system if it feels spongy when depressed.
