My Garage
My Account
Cart
Genuine GMC Terrain Crankshaft
Crank Shaft- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
7 Crankshafts found
GMC Terrain Crankshaft Assembly
Part Number: 12578164$594.73 MSRP: $944.25You Save: $349.52 (38%)Ships in 1-3 Business Days
GMC Terrain Crankshaft
Part Number: 12661873$430.57 MSRP: $749.39You Save: $318.82 (43%)Ships in 1-2 Business Days
GMC Terrain Crankshaft (Machining)
Part Number: 12637325$259.56 MSRP: $410.15You Save: $150.59 (37%)Ships in 1-3 Business DaysGMC Terrain Crankshaft Assembly
Part Number: 55504614$462.44 MSRP: $734.05You Save: $271.61 (37%)Ships in 1-3 Business Days
GMC Terrain Crankshaft
Each OEM GMC Terrain Crankshaft we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
GMC Terrain Crankshaft Parts Questions & Experts Answers
- Q: How can the crankshaft be removed from the engine after it has been taken out on GMC Terrain?A: The crankshaft can only be removed when the engine is completely detached from the car; provided that the driveplate, crankshaft pulley, timing chain, oil pan, oil pump body, oil filter, and Piston/connecting rod assemblies have been also removed. Before removal, but after loosening, check the crankshaft endplay using a dial indicator, zero it when you pry it to the rear then check it again when prying to the front from the rear; it should have average crankshaft endplay of between 0.003 - 0.010 inch. Sometimes it may not be possible to use the dial indicator; in this case, it is possible to use feeler gauges. For four cylinder models, turn both the lower crankcase and perimeter bolts gradually to a point that they can easily be unscrewed; then replace the lower crankcase bolts with new once while tightening them. Take off the lower crankcase after that, but be very careful not to lose the bearing inserts. Remove these then and for 3.4L engines lightening the main bearing cap bolts in the same manner for the 3.0L and 3.6L V6 models, remove the side bearing cap bolts. Remove the crankshaft from the engine using hoist and make sure the bearing caps of main bearings put back in position with the bearing insert in place. At installation, the engine block and crankshaft must be adsorbed; main bearing oil clearance check with Plastigage, and the width of the crushed ones relative to the scale. When clearance is not as specified, check on cleanliness and if necessary, get rid of bearing insert. On the removal of all the Plastigage residues, lubricate bearing surfaces with thin layer of grease or engine assembly for sub sequent laying of crankshaft back into place. Replace new main bearing cap bolts and tighten the bolts successively in accordance with the torque specifications and the crankshaft end play should also be checked. Then, turn the crankshaft to see if it binds; it should rotate freely with a running torque no more than 50 in-chosen units and replace the rear main oil seal.
