A: To remove the air conditioning system, start by discharging the system. Then, remove the air filter housing and the Radiator. Disconnect the two refrigerant lines for the condenser, making sure to plug all open lines and fittings to prevent contamination. Carefully guide the condenser out of the engine compartment and remove the sealing washers from the fittings and tubes. For installation, if a new condenser is being installed, pour one ounce of refrigerant oil into it before installation. Use new sealing washers when reconnecting the refrigerant lines and tighten the condenser line fitting nut to the specified torque. Finally, reverse the removal steps and have the system evacuated, recharged, and leak tested.