My Garage
My Account
Cart
Genuine Chevrolet Metro Steering Knuckle
Front Steering Knuckle- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
16 Steering Knuckles found
Chevrolet Metro Steering Knuckle
The Steering Steering Steering Knuckle in Chevrolet Metro is designed to connect the suspension order and the steering order in order to enable the movement of the front wheels. It has provision for control arms, tie-rod ends and the spindle or hub, allowing the up and down wheel movement as per road surface irregularities and out to in movement during steering. Chevrolet Metro steering knuckles can be sorted with respect to drive layouts- front wheel drive (FWD) and rear wheel drive (RWD). Fwd/awd/4wd models have an extended drive axle through the knuckle and terminating in a hub, while rwd cars might have an integral spindle or bolted-in hub. In terms of performance and durability the steering knuckle has advanced from the kingpin type to the current ball joint type. There must always be inspection more often as it is proven that some of these components may degrade especially after suspension work.
Each OEM Chevrolet Metro Steering Knuckle we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Chevrolet Metro Steering Knuckle Parts Questions & Experts Answers
- Q: How do you replace the steering knuckle and front wheel bearings?A: To replace the steering knuckle, start by raising and securing the front of the vehicle. Remove the front wheels, brake caliper, and brake disc and hub assembly. Take out the ball stud bolt and the clip retaining the brake line to the strut bracket. Then, remove the strut-to-knuckle bolts and finally, remove the knuckle. To replace the front wheel bearings, remove the bearings using a drift punch and hammer. Before installing the new bearings, pack them with wheel bearing grease and apply grease to the oil seal lip. Fill the space between the spacer and the knuckle with grease. Install the inner bearing, spacer, and outer bearing using a suitable driver, ensuring the sealed sides of the bearings face out. Center the spacer between the inner and outer bearings. Gently tap the oil seal into place, being careful not to deform or damage it. Finally, reinstall the steering knuckle.
