Each OEM Cadillac Escalade Steering Wheel we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Cadillac Escalade Steering Wheel Parts Questions & Experts Answers
Q: How do you remove and reinstall a steering wheel on Cadillac Escalade?
A: Before you attempt to remove the steering wheel, firstly, set the car with its wheels straight then turn off the car by removing the battery's negative terminal. switch of the air bag control system and the removal of all steering column shrouds. With the help of a small rod, turn the airbag and then free it from the steering wheel; pull the electrical connectors - to do this, find the lock, push down its sides with your fingers, and only then pull. Place the module flat down and venting with the side having the airbag attached to it down. Disconnect the electrical connector of the clockspring, loosen the nut of the steering wheel and scribe the position of the steering wheel on the shaft. After that, you could wiggle the steering wheel off the shaft using a puller if you have to, and lifting it while making sure that you guide the air bag module harness through the hub. Stepping on the brake pedal, it is necessary to align the Steering Shaft by turning the steering wheel clockwise or counter clockwise until the front wheels are pointing directly ahead and then the steering wheel must be reattached. Pull the clockspring connector wiring away from the clockspring, remove the snap ring and pull the clockspring up and out, releasing any tabs that may be in the way. Twist the hub in clock-wise direction until it does not move freely; then twist the hub in counter clockwise direction for 3 and 1/3 turns until the flat-wire cable loop is seen. Replace the clockspring around the steering column and secure in place, in-line with the horn tower and snap-ring in place as well as the electrical connectors. Slide the steering wheel into the appropriate position so that the wiring harness enters through the hub while the index marks well-coordinate. Tighten the steering-wheel nut, make secure connections of the air bag connectors and place the air bag module in its proper position at the steering-wheel and push the pins into position. Last of all, reconnect the negative terminal of the battery and then turn on the airbag system.