My Garage
My Account
Cart
Genuine Buick Skylark Fuel Pump
Gas Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
8 Fuel Pumps found
Buick Skylark Electric Intank Pump
Part Number: 25116162$47.56 MSRP: $136.40You Save: $88.84 (66%)Ships in 1-2 Business Days
Buick Skylark Fuel Pump Assembly
Part Number: 6472020$25.85 MSRP: $106.73You Save: $80.88 (76%)Ships in 1-2 Business Days
Buick Skylark Fuel Pump
Prior to the development of the Fuel Pump of Buick Skylark vehicles, the main responsibility was to transfer fuel from the tank to the carburetor or to the fuel injection assembly. In fuel injection system, electric pump is commonly used while in carbureted engines, mechanical pump is used. Secondary pumps- mechanical ones are made as part of the camshaft; the electric ones- are located inside the fuel tank; both supply fuel to the carburetor float bowl. Performance fuel pumps flow rate in GPH or LPH encases the sufficient number of fuel volumes and their pressure demanded by the engine for enhanced operation. Whereas the conventional pump has been used for pumping the fuel, the electric pump gives higher pressures and has efficiencies which are checked by the Electronic Control Units for safety and fuel metering.
Each OEM Buick Skylark Fuel Pump we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Buick Skylark Fuel Pump Parts Questions & Experts Answers
- Q: How to replace a mechanical pump on Buick Skylark,Oldsmobile Omega and Pontiac Phoenix?A: The process for replacing a mechanical pump on carbureted models involves disconnecting the battery cable, detaching the fuel inlet hose, outlet line, and vapor return hose, removing the mounting bolts, and retrieving the pushrod. After cleaning the block mounting surface and applying grease to the pushrod, the new gasket and pump are installed and the hoses and lines are reattached. For electric pumps on fuel-injected models, the fuel system pressure is relieved and the fuel tank is removed. The fuel pump/sending unit assembly is unlocked by turning the inner ring counterclockwise, and then lifted from the tank. The rubber gasket and strainer are inspected and replaced if necessary. If needed, the fuel pump can be separated from the sending unit. The assembly is then inserted back into the fuel tank and the inner lock ring is turned clockwise to engage the locking cams. Finally, the fuel tank is installed.
- Q: How to check the Fuel Pump and fuel system for Buick Skylark,Oldsmobile Omega and Pontiac Phoenix?A: For carbureted engines, ensure sufficient fuel, inspect fuel lines for leaks or damage, and test for a strong gasoline spurt when cranking the engine. If weak, assess the fuel pump and its flow capacity; it should pump a pint in 30 seconds. For fuel-injected engines, listen for the pump's whirring noise on ignition. If silent, inspect the fuse, relay, and circuit. To test the pump, apply battery voltage to its gray wire terminal. To verify the relay, use a test light and jumper wire. If there's an issue with fuel pressure, connect a gauge and check when the ignition is on. Low pressure might indicate a defective regulator, and high pressure could signify a blockage or faulty regulator. On MPFI models, check the regulator's function by observing pressure changes when detaching its vacuum hose.
