Saturn 19209807 Sensor Asm,Heated Oxygen (Position 2)

You can Select Your Vehicle to check if 19209807 fits your vehicle.

An oxygen sensor is a galvanic battery that produces a small voltage output in response to the amount of oxygen in the exhaust gases. This voltage signal is the input side of the feedback loop between the oxygen sensor and the Powertrain Control Module (PCM). Without it, the PCM would be unable to correct the injector on-time to maintain the perfect air/fuel ratio of 14.7:1 that the catalyst needs for optimal operation. All vehicles have On-Board Diagnostics II (OBD-11) engine management systems, which use an oxygen sensor ahead of the catalytic converter and another oxygen sensor behind the catalytic converter to verify the accuracy of the feedback loop. The models have two heated oxygen sensors: one upstream sensor located on the rear exhaust manifold and a downstream sensor located under the vehicle, behind the catalytic converter. Both sensors are heated to speed up warm-up time. When servicing a sensor, special care must be taken to avoid damaging the pigtail or electrical connector, keeping contaminants away, and not using cleaning solvents. Oxygen sensors are delicate and should not be dropped or handled roughly. The silicone boot on the sensor must be installed correctly to prevent melting. When replacing the upstream oxygen sensor, the ignition coil assembly may need to be removed for better access. The sensor can be unscrewed using an oxygen sensor socket, and if reusing the old sensor, anti-seize compound should be applied to the threads. The installation process is the reverse of removal. For the downstream oxygen sensor, the vehicle must be raised and securely placed on jackstands. The sensor can be located and disconnected, then unscrewed using an oxygen sensor socket. Again, if reusing the old sensor, anti-seize compound should be applied to the threads. The installation process is the reverse of removal.

After installing the oxygen sensor, you should tighten it to the specified torque.

The installation process is the reverse of removal, and it is important to tighten the oxygen sensor securely.

The heated oxygen sensors are heated to speed up warm-up time and ensure their efficient operation.

The installation process for the downstream sensor is the same as the upstream sensor, with the application of an anti-seize compound if necessary and ensuring a secure tightening of the sensor.