Saturn 22671496 Front Lower Control Arm Assembly

You can Select Your Vehicle to check if 22671496 fits your vehicle.

Remove the wheel after securely raising the vehicle.

To remove the trailing arm, first remove the brake shoe or disc brake assembly, ABS wheel speed sensor, and associated brackets. Unbolt the brake hose and brake line brackets, as well as the parking brake cable brackets. Remove the hub and bearing assembly, and suspend the brake backing plate out of the way. Remove the shock absorber/coil spring-to-trailing arm mounting bolt and the rear stabilizer bar link-to-trailing arm bolt. Support the trailing arm with a jack, then remove the bolts securing the upper and lower lateral control arms to the trailing arm. Mark the relationship of the trailing arm mounting bracket in relation to the vehicle chassis, then remove the bracket bolts and lower the trailing arm from the vehicle. Inspect the trailing arm pivot bushing for wear and replace if necessary. During installation, align the mounting bracket with match marks on the vehicle chassis, install the mounting bolts, and tighten them. Finally, tighten all other fasteners to their specified torque, and check and adjust the rear wheel alignment if needed.

To replace the lower lateral control arm, remove the lower control arm-to-trailing arm mounting bolt and nut, along with the fuel tank heat shield and fuel tank. Remove the pivot bolt from the inner end of the arm, noting that the rear stabilizer bar bushings may need removal for access. Inspect the control arm pivot bushing for wear and replace if needed. Reinstall the control arm following the reverse order of removal, tightening fasteners to the specified torque.

Install the control arm by following the reverse order of removal and tighten all of the fasteners to the specific torque values. Before tightening the control arm pivot bolts, raise the outer end of the control arm with a floor jack to simulate normal ride height.