Saturn 22684918 Rear Shock Absorber Kit

You can Select Your Vehicle to check if 22684918 fits your vehicle.

Loosen the rear wheel lug nuts. Chock the front wheels to keep the vehicle from rolling, then raise the rear of the vehicle and support it securely on jackstands. Remove the rear wheels. Remove the rear inner fender splash shield. Remove the shock absorber-to-trailing arm mounting bolt and washer. Support the shock, remove the shock carrier-to-body lower mounting bolts, then loosen the shock carrier-to-body upper mounting bolts and remove the shock. Remove the shock carrier's lower mounting bolts, then loosen the upper mounting bolts and remove the shock absorber/coil spring assembly. Installation is the reverse of removal. Tighten the bolts to the specific torque.

The first thing to do when replacing worn shock absorbers or coil springs is checking for typical signs of wear such as fluid leaks, loss of damping or damaged coil springs. Think about replacement options and check the parts availability. The shock absorber/coil spring assembly should be removed and the pressure on the upper spring seat released by means of a spring compressor. At this stage hold the shock damper shaft in one hand while the retaining nut is removed with the other hand. Other components like upper cup, insulator, top carrier, lower insulator, sleeve, lower cup and bump stop have to be removed as well. If you are replacing the spring, carefully release it from the compressor. Inspect all components for wear and replace as needed. When working with both assemblies, remember to label them left and right springs. The shock should be inspected for fluid leaks, pitting on the damper shaft or damage to the shock body. Its operation has to be tested for smooth uninterrupted resistance. Replace it in case of any found issues. The extended shock damper shaft should have rubber bump stop fitted onto it as well as lower cup, lower insulator and sleeve Install the compressed coil spring on lower seat ensuring that it contacts at its bottom most part Position upper spring seat on top carrier then install top carrier on shock damper shaft with coil spring such that the end of spring fits into upper seat's recessed portion When installing tightened upper insulator upon cup then retain nut Remove the compressing tool finally reinstalling assembly of absorber/shock coil.

Be cautious not to let the steering knuckle fall outward, as the brake hose could be damaged.

Laying out the removed parts in the correct order is important for inspection and reassembly purposes.

After installing these components, you should place the compressed coil spring onto the lower seat, ensuring it rests at the lowest part.

Laying out the removed parts in the correct order is important for inspection and reassembly purposes.

Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts to the specific torque. Finally, tighten the upper mounting nut to the specific torque.