Pontiac 9433728 V Belt Laminated

You can Select Your Vehicle to check if 9433728 fits your vehicle.

The drive belts, often called V-belts, are located on the timing chain end of the engine. Due to their composition and the high stresses they are subjected to, drive belts stretch and deteriorate as they age, necessitating periodic inspections. The number of belts used on a vehicle depends on the installed accessories, as they transmit power from the crankshaft to components such as the alternator, water pump, and air conditioning compressor. Depending on the pulley arrangement, a single belt may drive more than one component, while two belts may drive the same component on other models. Using your fingers, and a flashlight if necessary, move along the belts checking for fraying, cracks, and separation of the belt plies. Also, look for glazing, which gives the belt a shiny appearance. Both sides of each belt should be inspected, and each belt should be twisted to check its underside.

Check the tension of each belt by pushing on it at a distance halfway between the pulleys. Push firmly with your thumb and measure this deflection with a ruler. The belt should deflect 114-inch if the distance from pulley center to pulley center is between 7 and 11 inches. The belt should deflect 112:inch if the distance from pulley center to pulley center is between 12 and 16 inches. Another, more precise method of measuring and adjusting belt deflection is accomplished with special belt tension tools which are available from General Motors (J-23600-B or BT 33-95-ACBN). These tools measure the amount of force required to deflect a belt a specified distance. To adjust belt tension, loosen the pivot bolt(s) securing the belt-driven component to the engine block and the retaining nut or bolt securing the component to the slotted adjustment bracket. Use a levering device, such as a large screwdriver or pry bar, to pivot the component until the specified tension is achieved. Be careful not to damage either the component or the engine. Tighten the retaining nut or bolt securing the component to its slotted adjustment bracket snug enough to hold it. Check the belt tension again. Adjust as necessary. Tighten the component securely. If inspection reveals that a belt must be replaced, loosen the pivot bolt of the appropriate accessory (alternator, air conditioning compressor, etc.), slip the old belt off the crankshaft pulley and accessory pulley, then lift it out. Before installing the new belt, make sure it's the same width and length as the old one. Once the new belt is in place, tighten and adjust it just like you would a used belt.

Drive belts are crucial for the proper functioning of a car and its components.