Pontiac 22064136 Front Suspension Strut Kit

You can Select Your Vehicle to check if 22064136 fits your vehicle.

To remove and install the front shock absorbers, first loosen and remove the upper mounting nut, grommet retainer, and grommet, followed by the lower retaining screws. Once all retainer hardware is removed, lower the shock absorber through the hole in the lower control arm. Purge new shock absorbers of air by extending and compressing them while inverted. For installation, reverse the removal steps, ensuring the upper nut is tightened to 8 ft. lbs. (11 Nm) and the lower bolts to 20 ft. lbs. (27 Nm). For testing, visually inspect the shock absorber for signs of leakage; if oil is present, it indicates a defect requiring replacement. If there is no excessive leakage, bounce the vehicle by pressing down on the fender or bumper and releasing. The vehicle should stop bouncing after the first rebound; if it continues past the center point more than once, the shock absorbers are worn and need replacement.

New shocks should be purged of air by repeatedly extending them in their normal position and compressing them while inverted.

1. Raise the front end of the vehicle. 2. Use an open-ended wrench to prevent the upper end from turning. 3. Remove the upper stem retaining nut, retainer, and rubber grommet. 4. Remove the two bolts retaining the lower shock absorber pivot to the control arm and pull the assembly out from the bottom. 5. For installation, fit the lower retainer and rubber grommet over the upper stem. 6. Install the shock absorber in the fully extended position through the lower control arm and spring. 7. Fit the upper rubber grommet, retainer, and attaching nut. 8. Hold the upper stem with an open-ended wrench and torque-tighten the retaining nut. 9. Install the bolts at the shock absorber lower pivot and torque tighten before lowering the vehicle.