Pontiac 20794268 Front Suspension Strut Kit

You can Select Your Vehicle to check if 20794268 fits your vehicle.

To remove the strut, start by loosening the wheel lug nuts and raising the vehicle on jackstands. Remove the wheel and disconnect the stabilizer bar link from the strut. If the vehicle is equipped with ABS, detach the ABS harness from the strut. Mark the relationship of the strut to the knuckle for reference during installation. Remove the strut-to-knuckle nuts and knock the bolts out with a hammer and punch. Carefully separate the strut from the steering knuckle, being mindful of not overextending the inner driveaxle CV joint or damaging the brake hose. On certain models, such as Cobalt/G5 and HHR, remove the strut-to-body nuts in the engine compartment, while on ION models, remove the single upper mounting nut. Remove the strut assembly from the fender well. To inspect the strut, check for leaking fluid, dents, cracks, or any other obvious damage that would require repair or replacement. Examine the coil spring for chips or cracks in the spring coating, as this can lead to premature spring failure. Inspect the spring seat for cuts, hardness, and general deterioration. If any undesirable conditions are found, proceed to the strut disassembly procedure. To install the strut, guide the strut assembly up into the fender well and align the studs or locating pin through the holes in the shock tower. Install the mounting nut(s) to secure the strut in place. Slide the steering knuckle into the strut flange and insert the two bolts. Align the marks made during removal and tighten the nuts to the specified torque. Reattach the brake hose to the strut bracket and reconnect the stabilizer bar link. If applicable, install the ABS speed sensor wiring harness to the bracket. Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts to the proper torque. Finally, tighten the upper mounting nut(s) to the specified torque. It is recommended to have the front wheel alignment checked and adjusted if necessary.

Yes, for certain models like Cobalt/G5 and HHR, you'll need to remove the strut-to-body nuts in the engine compartment. For ION models, remove the single upper mounting nut.

To install the shock absorber, follow the reverse steps of removal, using new bolts and tightening them to the specified torque.

Before disassembling the vehicle, it is recommended to check the cost and availability of parts.

The strut and spring assembly should be removed, and the upper strut cap cover should be unbolted to expose the strut shaft nut. A spring compressor should be used to relieve pressure from the upper spring seat, and the damper shaft nut should be unscrewed while holding the strut rod in place.

If the shock absorber shows any visible wear or damage, or if the operation is jerky or uneven, it needs to be replaced.