Pontiac 22545259 Seal,Crankshaft Rear Oil

You can Select Your Vehicle to check if 22545259 fits your vehicle.

You can replace the one-piece type of a rear crankshaft seal without removing the engine. However, the transaxle must be removed and the engine supported during this process. First, remove the transaxle. Then, remove the pressure plate and clutch disc. Next, remove the flywheel. After that, remove the oil pan. Once the oil pan is off, there are bolts to be removed and then you can detach the seal housing along with peeling off all old gasket material from it. On a workbench, position the seal housing on top a couple of wooden blocks and drive out the old seal with a punch and hammer from the backside through. Don't cock seat in housing bore; just try to drive new seal into it using a block of wood or section of pipe if you have one large enough. Lubricate with moly-base grease for crankshaft seal journal and lip of new seal. Position new gasket on engine block. Slowly push new seal onto crankshaft. When you push housing against block as you work stiff lip over crankshaft with the end of an extension which is smooth, keep your eye on posture. Note: Slowly refers to pushing new seal on crankshaft. Actually, it should precede "slowly push". By install, tighten housing bolts. Finally, reinstall the transaxle.

The seal lip should be lubricated with moly-base grease or engine assembly lube.

Reinstall the vibration damper.

The first step is to remove the flywheel/driveplate.

Wrap the screwdriver tip with vinyl tape to protect the crankshaft.

Lubricate the seal lip with moly-base grease or clean engine oil.