Pontiac 12685965 Water Pump Kit

You can Select Your Vehicle to check if 12685965 fits your vehicle.

A failure in the water pump can cause serious engine damage due to overheating as the pump will not be able to circulate cooled water through the engine. There are three ways in which to check the operation of the water pump while it is still installed on the engine. If the pump is suspect, it should be replaced with a new or factory-rebuilt unit. With the engine warmed up to normal operating temperature, squeeze the upper radiator hose. If the water pump is working properly, a pressure surge should be felt as the hose is released. Water pumps are equipped with 'weep' or vent holes. If a failure occurs to the bladder of the pump, small amounts of water will leak from these 'weep' holes. In most cases, it will be necessary to use a flashlight from under the car to see evidence of leakage from this point in the pump body. If the water pump shaft bearings fail, there may be a squealing sound at the front of the engine while it is running. Shaft wear can be felt if the water pump pulley is forced up and down. Do not mistake drive belt slippage, which also causes a squealing sound, for water pump failure.

Start the engine and warm it up to normal operating temperature, then squeeze the upper radiator hose.

Start by disconnecting the cable from the negative terminal of the battery.

Disconnect the wiring at the rear of the alternator and remove the alternator pivot bolt.

If the water pump is suspect, it should be replaced with a new or factory-rebuilt unit.

On vehicles with power steering, the adjusting bolt should be loosened, and the pivot bolt should be removed to swing the power steering pump away from the engine.

Transfer the heater hose fitting from the old pump to the new one.

A failure in the water pump can cause overheating and serious engine damage as the pump will not circulate coolant through the engine.