Pontiac 20841713 Insulator,Front Stabilizer Shaft

You can Select Your Vehicle to check if 20841713 fits your vehicle.

To remove the sway bar on a vehicle, start by loosening the front wheel lugnuts and raising the front of the vehicle. Support it securely on jackstands and remove the front wheels. Next, remove the nuts that attach the sway bar link to the strut coil spring assembly and to the sway bar, and detach the links. Then, remove the bolts from the sway bar bushing retainers and pry them off if necessary. Inspect the bushings for any cracks or tears, and if they are damaged, replace both of them. Additionally, if the ball studs on the links are loose or worn, replace the links. To install the sway bar, start by tightening the link nuts to the proper torque specifications. Then, clean the areas on the sway bar where the bushings are located and lubricate the inside and outside of the new bushings with vegetable oil. Install the bushings with the slit in each bushing facing towards the rear of the vehicle. Next, install the retainers and bolts, tightening them to the proper torque specifications. Finally, install the wheels and lug nuts, lower the vehicle, and tighten the wheel lug nuts to the proper torque specifications.

Start by loosening the rear wheel lug nuts and blocking the front wheels to prevent rolling.