Pontiac 88957254 Drum Asm,Rear Brake

You can Select Your Vehicle to check if 88957254 fits your vehicle.

Whenever the disc brake pads are checked for wear, it is also necessary to look at the state or condition of the discs or rotors. Thus, ligth scoring or grooving are expected but deep grooves or severity erosion are not permitted. Some models have a specific channel, the so-called squeal groove, which should not be confused with damage. The existence of a vibration when the brake is applied has also been attributed to disc run out. To check for this, a dial gauge or feeler blades may be used between the disc and any fixed point. It was established that the disc should be turned at a slow rate in order not to exceed the runout of 0.004 inches. Thickness variations that are above the 0.0005 inches may also imply that the disc will vibrate during braking. Discs usually have wear limit and refinish thickness dimensions moulded on them. On the other hand, if a dealer fails to refinish a disc to certain standards of the set tolerance, a new disc has to be fitted. When a brake drum is pulled on a particular scheme for a lining inspection, it is necessary to look for cracks, 'scoring,' and out-of-round conditions. An out-of-round drum results in pulsations felt through the brake pedal during the application and the internal diameter has to be checked at various positions using an internal micrometer. Drums may be refinished internally; however, the wear and refinish sizes that may be cast into them must not be exceeded.

Raise the rear of the car and support it with jackstands, remove the wheel and tire assemblies, make sure the parking brake is off, and back off the brake adjuster if necessary. Tap the drum with a hammer in several places if it is stubborn. Installation is in the reverse order of removal and the brakes should be adjusted after installation.

Machine the drum as necessary while adhering to the maximum machine diameter specification.