Pontiac 10023655 Bracket,Engine Mount

You can Select Your Vehicle to check if 10023655 fits your vehicle.

You can check the mounts by pushing upward and pulling downward on the transaxle case.

Inspect for hardening or cracking of the rubber, or separation of the rubber from its metal backing.

Inspect for hardening or cracking of the rubber, or separation of the rubber from its metal backing.

They need to be replaced, which can be done with the engine/transmission still in the vehicle.

Check that all attaching screws or nuts are tight on the crossmember and the transmission.

If the rubber separates from the metal plate, it means that the mount needs replacement.

If the rubber separates from the metal plate or if the case moves up but not down, replacement is necessary. Additionally, if there is movement between the metal plate and its attachment point, you should tighten the bolts or nuts.

Reinstall the engine compartment lid and side cover panels.

To inspect the rear mount, elevate the vehicle and push up and down on the transmission tailshaft while observing the mount. If the rubber separates from the metal plate or the tailshaft moves excessively, replace the mount. If there is movement between the mount's metal plate and the attachment point, tighten the bolts or screws.

You can check the mounts by pushing upward and pulling downward on the transaxle case.

1. Support the engine and transaxle. 2. Remove the necessary bolts and nuts. 3. Replace the mount. 4. Tighten all components to the specified torque.

Yes, general instructions are provided on how to raise the engine sufficiently to replace the mounts.

1. Remove the bolts connecting the forward support bracket to the transaxle. 2. Take off the mount-to-support bracket nut and the mount-to-cradle nuts. 3. Remove the forward support bracket and the mount itself. 4. Position the new mount and install the mount-to-cradle nuts loosely. 5. Place the transaxle support bracket and install the mount-to-support bracket nut and the bracket-to-transaxle bolts loosely. 6. Ensure all mounting hardware is loose, lower the jack until the transaxle centers the mount, and then tighten the hardware to the specified torque before reconnecting the negative battery cable.

1. Remove both strut bolts. 2. Install the front strut bolt loosely. 3. Push the engine back to install the rear strut bolt. 4. Tighten both bolts to the specified torque.