Pontiac 12697768 Balancer Assembly, Cr/Shf

You can Select Your Vehicle to check if 12697768 fits your vehicle.

This procedure requires a special pulley installation tool and a new crankshaft pulley bolt. Before proceeding, read through the entire procedure and obtain the necessary tools and materials. Start by disconnecting the cable from the negative battery terminal. Raise the vehicle and support it securely on jackstands. Remove the drivebelt. Install an engine support fixture or an engine hoist to the engine lifting bracket on the right side. Alternatively, the engine may be supported from below the oil pan with a floor jack and a block of wood. If this is done, position the wood and the jack to avoid damaging the oil pan. Tighten the engine support chain to remove the weight from the engine mounts. Remove the right side engine mount. Carefully lower the engine about two inches for clearance. Remove the crankshaft pulley bolt. Prevent the crankshaft from turning by removing the starter motor and wedging a large screwdriver or pry bar in the drive plate ring gear teeth. Install a large three-jaw puller on the pulley, and remove the pulley. Make note of how far the pulley is pressed onto the crankshaft. It must be installed in the same position. Use the puller to draw the pulley from the crankshaft. Lubricate the inside of the pulley bore with clean engine oil. Don't let oil contact the outside of the pulley's snout or the oil seal in the timing chain cover. The pulley must only be installed into a dry seal. Obtain a crankshaft pulley installation tool. Use only this tool to press the pulley into place. Install the pulley in its original position. The installation tool should be bottomed on the end of the crankshaft. Remove the installation tool. Install the new crankshaft pulley bolt. Have an assistant wedge the large screwdriver or pry bar in the drive plate ring gear teeth, then tighten the bolt to the torque and angle of rotation. The remainder of installation is the reverse of removal.