Oldsmobile 15763214 Steering Wheel Assembly *Ebony

You can Select Your Vehicle to check if 15763214 fits your vehicle.

Park the vehicle straight and disconnect the battery's negative terminal. If equipped with an airbag, disable it. On non-airbag models, detach the horn pad. For pre-1996 airbag models, remove screws from the steering wheel's back. On 1996 and later, turn the wheel 90 degrees, accessing holes to release pins using a screwdriver. Lift the airbag module, disconnect the connector, and remove. Take off the horn plunger, retaining nut, mark the wheel's position if needed, then use a puller to detach the steering wheel. Disconnect horn and ground connectors. For installation, reverse the steps, center the SIR coil for airbag models, and tighten all components to specified torque.

Remove the horn contact plunger and contact plate, and unplug the yellow electrical connector on airbag-equipped models.

Start by disconnecting both cables from the battery.

Use a puller to detach the steering wheel from the shaft, avoiding hammering on the shaft.

Simply pry off the horn cap.