Oldsmobile 15993849 Shaft, Front Stabilizer (33Mm Bar Diameter)

You can Select Your Vehicle to check if 15993849 fits your vehicle.

To uninstall the sway bar kit, you must first raise the rear of the vehicle and securely support it by using jack stands. Set up blocks on the front wheels to stop the car from rolling off its stands. Afterwards, remove the lower nuts, washers and bolts from sway bar kit-to-frame bracket links. Then remove U-bolt nuts and pull off the sway bar kit clamps. Finally, take out whole sway bar kit assembly. Also check for cracks, tears or deterioration in all sways bar kit and link bushings after removal to replace them if necessary. In short, undoing these steps should be followed with tightening of all fasteners up to torque specifications while installing a new sway bar kit.

After raising the vehicle and supporting it securely on jackstands, you should remove the nuts from the link bolts and take out the link bolts.

Remove the nuts from the U-bolts and take off the stabilizer bar clamps.

To remove the stabilizer bar, start by raising the vehicle and supporting it securely on jackstands.

To remove the stabilizer bar, start by raising the vehicle and supporting it securely on jackstands.

Simply reverse the removal steps and make sure to tighten all fasteners to the proper torque.

Simply reverse the removal steps and make sure to tighten all fasteners to the proper torque.

To remove the stabilizer bar, start by raising the vehicle and supporting it securely on jackstands.