Oldsmobile 10228655 Seal,Crankshaft Front Oil

You can Select Your Vehicle to check if 10228655 fits your vehicle.

Remove the crankshaft pulley and vibration damper. Note how the seal is installed-the new one must be installed to the same depth and facing the same way. Carefully pry the Crankshaft Seal out of the cover with a seal puller or a large screwdriver. If the Crankshaft Seal is being replaced with the timing chain cover removed, support the cover on top of two blocks of wood and drive the Crankshaft Seal out from the backside with a hammer and punch. Clean the seal bore to remove any old seal material and corrosion. Position the new Crankshaft Seal in the bore with the seal lip (usually the side with the spring) facing IN(toward the engine). A small amount of oil applied to the outer edge of the new Crankshaft Seal will make installation easier. Drive the Crankshaft Seal into the bore with a seal driver or a large socket and hammer until it's completely seated. Select a socket that's the same outside diameter as the Crankshaft Seal and make sure the new Crankshaft Seal is pressed into place until it bottoms against the cover flange. Check the surface of the damper that the Crankshaft Seal rides on. If the surface has been grooved from long-time contact with the seal, a press-on sleeve may be available to renew the sealing surface. This sleeve is pressed into place with a hammer and a block of wood. Lubricate the seal lips with engine oil and reinstall the vibration damper. Use a vibration damper installation tool to press the damper onto the crankshaft. Install the vibration damper-to-crankshaft bolt and tighten it to the torque specifications. Install the crankshaft pulley and tighten the bolts to the torque specifications. The remainder of installation is the reverse of removal.

Remove the crankshaft balancer. Note how the seal is installed the new one must be installed to the same depth and facing the same way. Carefully pry the oil seal out of the cover with a seal puller or a large screwdriver. Be very careful not to distort the cover or scratch the crankshaft! Wrap the electrician's tape around the tip of the screwdriver to avoid damage to the crankshaft. If the seal is being replaced with the timing chain cover removed, support the cover on top of two blocks of wood and drive the seal out from the rear with a hammer and punch. Apply clean engine oil or multi-purpose grease to the outer edge of the new seal, then install it in the cover with the lip (spring side) facing IN. Drive the seal into place with a large socket and a hammer (if a large socket isn't available, a piece of pipe will also work). Make sure the seal enters the bore squarely and stops when the front face is at the proper depth. Check the surface on the balancer hub that the crankshaft seal rides on. If the surface has been grooved from long-time contact with the seal, replace the crankshaft balancer. Lubricate the balancer hub with clean engine oil and reinstall the crankshaft balancer. The remainder of installation is the reverse of removal.

Position the new seal with the open end facing in.

It's important to note how the seal is installed because the new one must be installed to the same depth and facing the same way.

Position the new seal with the open end facing in.

If the seal is being replaced with the timing chain cover removed, support the cover on top of two blocks of wood and drive the seal out from the rear with a hammer and punch.

The depth to which it is recessed into the housing bore.

The seal should be placed over the end of the crankshaft and carefully tapped into place.

Thoroughly with a shop towel, removing all traces of oil and dirt.

The seal should be placed over the end of the crankshaft and carefully tapped into place.