Oldsmobile 12605565 Filter Assembly, Oil (Cap W/Filter & Seal)

You can Select Your Vehicle to check if 12605565 fits your vehicle.

Vehicles equipped with an oil life indicator system illuminate a light or message on the instrument panel to signal the need for an oil change, typically allowing for extended intervals compared to the traditional 3000-mile mark, but it's recommended not to exceed 10,000 miles between changes. Frequent oil changes are crucial for preventive maintenance as aging engine oil becomes diluted and contaminated, contributing to premature engine wear. Before initiating the oil change, ensure you have the necessary tools and ample rags or newspapers for oil spills. Access to the oil drain plug and filter is improved when the vehicle is raised on a hoist, driven onto ramps, or supported by jackstands. Start the engine and let it reach normal operating temperature, facilitating easier oil drainage. Park on a level surface, shut off the engine, and remove the oil filler cap. Raise the vehicle, supporting it securely with jackstands. Carefully position a drain pan beneath the engine's drain plug, remove the plug with a proper-sized wrench, and be cautious of hot exhaust components. After draining, inspect the old oil for metal particles, clean the drain plug, and the surrounding area, then reinstall and tighten it. Move the drain pan under the oil filter, unscrew the filter cap, and remove both the cap and element. Clean the housing and cap thoroughly. Install a new O-ring seal and a new filter element into the cap, then insert them into the filter housing, securely tightening the cap. Lower the vehicle, add fresh oil through the filler cap using a funnel, and check the oil level with the dipstick. Start the engine for a minute, inspect for oil leaks, and recheck the dipstick. During initial trips after the oil change, monitor for leaks and proper oil levels. Properly dispose of the old oil by checking with local facilities or recycling centers. Lastly, reset the "Change Engine Oil" light using either of the two specified methods, depending on your vehicle's features, ensuring the Oil Life Monitor is successfully reset.

Regular oil changes and maintenance are essential for engine longevity and performance because they help keep the engine lubricated with clean oil, prevent premature wear, and ensure the engine operates at its best. This contributes to overall vehicle reliability and efficiency.

Start the engine and let it reach normal operating temperature, facilitating easier oil drainage. Park on a level surface, shut off the engine, and remove the oil filler cap.

Access can be improved by raising the vehicle on a hoist, driving it onto ramps, or supporting it with jackstands.

For V6 models, the oil filter should be removed and replaced using an oil filter wrench. For four-cylinder models, the canister-type oil filter can be accessed from the top of the engine.