Oldsmobile 15293528 Front Lower Control Arm Assembly *"No Color"

You can Select Your Vehicle to check if 15293528 fits your vehicle.

Yes, if necessary, remove the air cleaner extension. Also, disconnect the brake hose bracket and ABS wheel speed sensor from the upper control arm.

To remove the control arm on a 2WD model, start by loosening the wheel lug nuts and raising the vehicle on jackstands. Remove the wheel and then the coil spring. Disconnect the lower balljoint and take the control arm to a dealer or properly equipped shop for any necessary replacements of the balljoint and bushings.

To remove the control arm on a 2WD model, start by loosening the wheel lug nuts and raising the vehicle on jackstands. Remove the wheel and then the coil spring. Disconnect the lower balljoint and take the control arm to a dealer or properly equipped shop for any necessary replacements of the balljoint and bushings.

Remove the pivot shaft nuts, bolts, and shims, noting their location.

To install the control arm using the alternative method, raise it into position and install the control arm pivot bolts, washers, and nuts without fully tightening them. Carefully raise the lower control arm with a floor jack until the balljoint stud can be inserted into the hole in the steering knuckle. Install the balljoint stud nut, tighten it to the proper torque, and install a new cotter pin. Install the torsion bar, connect the stabilizer bar, and install the shock absorber. Finally, install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts to the torque specifications. Tighten the lower control arm pivot bolts to the correct torque specifications and install the splash shield if applicable. Measure the vehicle's ride height on each side and adjust the torsion bar accordingly until the vehicle sits level.

Position a floor jack with a wood block under the lower control arm.

To install the control arm using the alternative method, raise it into position and install the control arm pivot bolts, washers, and nuts without fully tightening them.

Start by loosening the wheel lug nuts and raising the front of the vehicle on jackstands.