Oldsmobile 19300025 Rear Leveling Shock Absorber Kit

You can Select Your Vehicle to check if 19300025 fits your vehicle.

Smooth operation, and replace if necessary.

Have the front-end alignment checked and adjusted if needed.

Check the strut body for leaking fluid, dents, cracks, and other obvious damage that would require repair or replacement.

Install the strut coil spring assembly. Once the strut is in place in the strut tower, install the upper mounting nuts or bolts to prevent the strut coil spring assembly from falling back through. This may require an assistant due to the weight and awkwardness of the strut. If equipped, reconnect the electrical connector to the strut. Slide the steering knuckle into the strut flange and insert the two bolts, with the bolt heads pointing towards the front of the vehicle. Install the nuts, align the marks, and tighten them to the specified torque. On 1999 models, reconnect the stabilizer bar link to the strut and tighten the nut to the specified torque. Reconnect the brake hose and ABS harness brackets to the strut, tightening the bolts securely. Install the wheel, lower the vehicle, and tighten the lug nuts to the specified torque. Finally, tighten the three upper mounting nuts or bolts to the specified torque.

Start by loosening the rear wheel lug nuts and raising the rear of the vehicle on jackstands.

Depending on the model, remove the nut and bolt or two bolts securing the shock absorber to the control arm.

This rear shock comes with 12 months or 12,000 miles

No, these are not meant for a 2006 Cadillac DTS